Blooming Peony Wrapped in Deer Antlers Bas-Relief STL

A full peony opens at the center, petals layered and soft, while a pair of deer antlers sweep around it like protective arms. Leaves fan out to the edges and a couple of mushrooms tuck into the corners. It is the kind of piece that looks at home above a fireplace in a hunting cabin or framed in a farmhouse hallway, where the floral softness and the wild antlers meet in one carve. This is a high-detail bas-relief STL built to read clean on the machine. The petals hold their depth, the antler tines stay crisp, and the leaf veins come through sharp instead of muddy. It started as a hand-carved original that was 3D scanned, so you keep that real wood-grain character and a finish that feels made by hand rather than spit out by a computer. The file is ready for Aspire, VCarve Pro, Carveco, and ArtCAM, and it runs nicely on a CNC router, a laser engraver using a heightmap workflow, or an FDM or resin 3D printer. For best results, rough it out with a 6mm end mill at 40 percent stepover, then come back with a 3mm ball nose at a 10 percent stepover to pull out the fine petal and antler detail. Scale it to fit a small plaque or a wide statement panel. You get an instant digital download with commercial use included, so carve it for your own wall, cut a run of signs and plaques, or build it into a gift for the hunter or flower lover in your life. Download it, load your toolpaths, and start cutting today.